Columbia THERAPEDIC 2000 Manuale del Proprietario

Model #2500 Model #2000 Therapedic™ Positioning Restraint System Model #2000 and Model #2500 Instructions for Use MODEL #2000: Use only with indi

10 Installation The Therapedic Positioning Restraint System must be in-stalled with a Tether Strap which is included. The tether strap must be atta

11 5. Pull the seat belt out completely to engage the retractor, then route the belt between the back of the restraint and the metal tubes which are

12 1. Place the Positioning Restraint System in a forward facing position on the vehicle seat. If the front edge of the re-straint extends more th

13 Combination Lap/Shoulder Belt with Locking Clip vehicle does not have a top tether anchor point, it will be necessary to use a bolt-in anchor moun

14 5. Pull the lap belt out completely, then route the belt between the back of the restraint and the metal tubes which are located along the sides

15 Installing the Tether Strap LATCH Vehicle Installation The TheraPedic Positioning Restraint System includes a top an-chorage strap, known as

16 • An incorrectly mounted restraint system may come loose dur-ing an accident which could result in serious injury or death to the user. • Damage

17 Single hook attachment for individuals under 80 lbs. (36kg) 3. Attach one tension adjuster hook to the upper side anchor bracket lo-cated on each

18 • For individuals greater than 80 lbs. (36 kg): use two (2) tether hooks attaching one (1) tether hook to the tether anchor immediately behind t

19 The Therapedic Positioning Re-straint System includes the follow-ing standard components: • 5-Point Safety Harness • Shoulder Harness Pads •

Important Safety Information ...Page 3 Vehicle Seat Belt Compatibility...Page 6 V

20 Checking the Harness Height 1. Place the user in the Positioning Restraint System and properly secure with the har-ness. 2. Note the position of

21 Adjusting the Harness Fit 1. With the user in the restraint, check the location of the buckle. 2. The buckle should be positioned at the level o

22 4. Press the button on the plastic ball, sliding the head pad along the lanyard to the desired height, then release the button to se-cure the hea

23 Swing-Away Abductor The swing-away abductor is used to improve hip alignment and stabilize seating posture. Shurshape™ Custom Inserts A unique w

24 Securing the User in the Restraint Once the Therapedic™ Positioning Restraint System has been properly fitted and installed in the vehicle, fo

25 Cleaning Instructions Removing the Cover • Remove the head pads and positioning pads (if present) by releasing the lanyards from the back of

26 Cleaning the Harness and Buckle • The harness straps may be cleaned by sponging them with warm water and a mild detergent. • The buckle may be

27 Copy of Registration Card FOR YOUR SAFETY Please promptly fill out and return the attached card. Although positioning restraint systems undergo t

13577 Larwin Circle Santa Fe Springs, CA 90670 (310) 454-6612 (800) 454-6612 Fax: (310) 305-1718 Email: [email protected] Website: www.columbi

3 WARNING! DEATH OR SERIOUS INJURY can occur: MODEL #2000: Use only with individuals who weigh between 20 and 102 pounds (9.1— 46.3 kg) and who

4 • This Positioning Restraint System is designed to fit a wide range of individuals. To ensure a proper fit for the user, it is important that the

5 • The harness assembly is for use only with the Therapedic Posi-tioning Restraint System. Do not use the harness independently of the seat. • I

6 IMPORTANT: Vehicle seats and safety seat belts differ from vehicle to vehicle. Always refer to your vehicle owner’s manual or call the vehicle

7 • Lap belts with an emergency locking retractor (ELR), which means that the lap belt will only lock in the event of a sudden stop or crash. • Mo

8 1. Adjustable Head Pads 2. Shoulder Harness Pads 3. Lateral Positioning Pads (under cover) 4. Crotch Strap Pad 5. Chest

9 1 3 2 4 10 6 11 7 9 8 10